Elektron Monomachine Uživatelský manuál stáhnout pdf (Strana 111)

GLOBAL SETTINGS

103

3. Put the receiving device into a waiting state, ready

to receive data.

4. Press [ENTER/YES] to make the Monomachine send the waveform. The screen will

indicate that a waveform has been sent.

• It is not possible to send factory waveforms. If you try to do so, the message “NOT

A USER WAVEFORM” will be displayed on the screen.

• You can always cancel the send operation. When sending, just press the [EXIT/

NO] key.

• Use the TM-1 MIDI interface available from Elektron for up to 10x the normal MIDI

transfer speed.

ERASE WAVEFORMS

You can erase either all waveforms at once or just a single waveform. When a user wave-

form is erased, it will be replaced by the factory waveform stored on that particular position.

You can not erase the factory waveforms.

To erase all waveforms, follow the instructions below.

1. When in the DIGIPRO MGR, choose ERASE and then press the [RIGHT] arrow key to

move the focus to the POS NAME column. Choose ALL.

2. Press [

ENTER/YES]. A prompt will appear on the screen as seen below.

3. Press [ENTER/YES] to erase all waveforms. To cancel the erase operation, press

[EXIT/NO].

To erase a single waveform, follow these instructions:

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 157 158

Žádné komentáře

Elektron Monomachine Uživatelský manuál Strana 111